Curtain fabric is often one of the first things to go wrong in a home. It’s easy for them to get stretched out, torn and generally worn out over time. Why? Because curtains are typically treated like clothes—they’re pulled back and forth, swooshed around and used as a tool for decoration rather than for shelter. Fortunately, this doesn’t have to be the case. In this blog post, we’ll show you how to fix curtains without breaking the bank. We’ll also provide some tips on how to choose curtain fabric that will last and look good while doing it.
What You'll Need
If you're like most blackout curtains, your curtains are probably a little on the old side and need to be replaced. But with a few simple supplies and some DIY know-how, you can easily fix most curtain problems without breaking the bank.
First, determine the cause of the problem: is it too tight or too loose? If it's too loose, you can try using a curtain rod to hold up the curtain liner. If it's too tight, you might need to replace the curtain fabric.
Next, gather your materials: a drill, screws, brackets (if necessary), and curtain liner. Follow these steps to install a new curtain panel:
1) Drill holes in brackets at desired height. Make sure brackets are level so that panels hang evenly. Use screws to attach brackets to wall.
2) Place liner onto hooks on brackets. It's helpful if one person holds both ends of liner while another person screws in screws.
3) Hang panels by adjusting screws on either side of brackets until panels hang evenly and look how you want them to look. (Ideally, panels should be mounted about two feet away from window so they don't block light.)
The Basic Method
Fixing curtains without breaking the bank is possible with a few simple steps. First, determine the size of the curtain and cut the fabric to that size. Next, hem the bottom of the curtain and attach it to the rod using snaps or pins. Finally, hang the curtain using tension rods or hooks.
Step-By-Step Instructions
If you're like many homeowners, your curtains are looking a bit worse for wear and need some TLC. But, before you go out and buy new ones, why not try repairing them yourself? This DIY tutorial will show you how to repair curtains without breaking the bank.
1. Remove the curtain rod from the curtain fabric. If the curtain is sheer, remove a piece of fabric about 2 inches wide along one edge of the curtain so that you can see the hem.
2. Measure the distance from one end of the rod to the other, and draw a line on the fabric with a pencil. Cut along this line with scissors. Try not to cut too close to the rods themselves; you just want to Sever off enough fabric so that you can fit your fingers between it and the rod.
3. Hold one end of each shortened rod in your hand and slide them up over each shortened end of fabric until they reach their new positions on both sides of the window or doorframe (depending on where they were originally attached). Make sure that they're aligned correctly so that there's no wrinkles or damage in between them when they're in place.
4. Push down on curtains installation rod until they're firmly in place and hold tight with pliers if necessary (you don't want them coming loose while you're working!). Repeat on opposite side of window/doorframe.
How To Fix Curtains Without Breaking The Bank
Fixing curtain rods without breaking the bank can be a daunting task, but there are a few tricks of the trade that will make the process much easier. One easy way to fix curtains without any damage is to use pliers. Simply grip the curtain rod near the end and twist it in the opposite direction. This should loosen the rod from the brackets and allow you to pull it out of the window. If your curtains are caught on one of the curtain rings, you can use a needle-nose pliers to grab hold of both ends of the ring and pull it free. If your curtains are just too tight to move, you can use a flat head screwdriver to pry them away from the window frame.
Comments